|
Sensitivity (for full rated power at 4 ohms) |
1.4 Vrms |
|
Frequency Response (at 1 watt, 20 Hz - 20 kHz) |
+0 dB, –1 dB |
|
Signal-to-Noise Ratio |
Rated as dBr to full rated 8Ω power output (A-Weighted):
XLS1000 > 97 dB
XLS1500, XLS2000, XLS2500 > 103 dB |
|
Damping Factor (8 ohm): 10 Hz to 400 Hz |
> 200 |
|
Crosstalk (below rated 8Ω power) |
At 1kHz: > 85dB
At 20kHz: >55dB |
|
Input Impedance (nominal) |
20 kΩ balanced, 10 kΩ unbalanced |
|
Load Impedance |
2 to 8 Ω per channel in Stereo
4 to 8 Ω in Bridge Mono |
|
AC Line Voltage and Frequency Configurations Available (± 10%) |
120 VAC 60 Hz
100 VAC 50/60 Hz
220 and 240 VAC 50 Hz |
|
Ventilation |
Flow-through ventilation from front to back |
|
Cooling |
Internal heat sinks with forced-air cooling for rapid, uniform heat dissipation |
|
Air Volume Requirements (per minute per unit) |
80.15 ft³ (2.27 m³) |
|
Integrated Processing |
PureBand™ Crossover System
Crossover Filter: Linkwitz-Riley 24dB per Octave
:NAMESPACE PREFIX = ST1 />Crossover Frequency Range: 50 HZ - 3 kHz
Crossover Mode: Crossover (CH1=LPF, CH2=HPF), LowPass (both channels LPF), HighPass (both channels HPF), Bridge (LPF or HPF).
Peakx™ limiters: Channel independent clip limiter designed to
provide maximum output while protecting your loudspeakers |
|
Input/Output |
Input Connectors: XLR (one per channel), 1/4-Inch (one per channel), and RCA (one per channel). 1/4-Inch connectors can be used as loop-thrus to distribute signal to additional amplifiers.
Output Connectors: Two 4-Pole Speakon? Output Connectors
accept 2-pole or 4-pole Speakon? connectors. The top Speakon connector is wired for both channels so it can be used for bridgemono wiring or for stereo wiring of two speakers to a single Speakon connector.
One pair of back-panel binding posts per channel; accepts
banana plugs or bare wire. (European models do not accept
banana plugs.) |
|
Construction |
XLS1000/XLS1500: 8.12-Inch (20.62cm) depth
XLS2000/XLS2500: 10.35-Inch (26.29cm) depth |
|
Dimensions |
EIA Standard 19-inch (48.3-cm) rack mount width
(EIA RS-310-B), 3.5-inch (8.9-cm) height.
XLS 1000/1500: 7.7-inch (19.6-cm) depth.
XLS 2000/2500: 10.7-inch (27.2-cm) depth. |
|
Net Weight , Shipping Weight |
XLS1000: 8.6 lb (3.9kg), 13.6 lb (6.2 kg)
XLS1500: 8.6 lb (3.9kg), 13.6 lb (6.2 kg)
XLS2000: 10.75 lb (4.9kg), 15.8 lb (7.1 kg)
XLS2500: 10.75 lb (4.9kg), 15.8 lb (7.1 kg) |
